Why I Oughta...

I'm always very hesitant to use my table saw in my shop.  If there's another tool that will get the job done, I usually chose it.  But, there are plenty of instances that call for a table saw.  To stack the odds in my favor, I usually am very deliberate with the saw and use a push stick and keep my hands away from anything moving during the cut and way long after the blade stops. But, I've started to use this thing:  The Grr-Ripper to 'bulletproof' my hands.  You use this thing to guide the piece through the cutting zone.  See below for the channel that the blade runs through. I won't use the saw without this thing now.  I'm not even doing it justice, so if you have interest, check out this video below that explains everything about it as they call it a "must-have for any table saw."

As I was doing some work to cut plywood for a garage project, I made a mistake and there was a pretty big spark.  Somehow, my circular saw cord got caught up on itself and I sliced it right open.  Amateur hour, right?  I texted this photo over to my father-in-law and asked him if it was repairable and he said:  yep!  Easy fix.  So, I stuck this saw in my car and the next time I head over there, I'll drop it off for him to repair.  The good news is that I wasn't electrocuted.  Between the GFI and the plastic handle, I didn't learn this lesson the hard way. 

After months of planning and thinking and posting about my eventual workshop, we finally have progress:  the wall that divides the rest of our basement with my shop is getting installed.  In the photo above, you can see the wall being framed and the steel door - an exterior door - installed.  On the right side of the photo - through the framing - you can see the existing stairs and banister coming down from the first floor.  In the middle of the room, you can see an existing door/wall that built out by our builder to contain the mechanical room.  They used a steel, exterior door on the mechanical room, so we replicated that with the door for my shop.  They're going to be so close, so it was important for them to match. Right after the wall framing is done, drywall is going on the outside, but I'm going to leave the inside unfinished.  I'm still planning on cutting in a spot for a vent ( see here for inspiration ) and stuffing the joist cavities with insulation so we ca

My father-in-law gifted me this Sears Craftsman 8-function Multimeter for Christmas and I've just gotten around to unboxing it and finding it's permanent home in my shop.  I wasn't quite sure what to do with a multimeter (or multi-meter as it is sometimes spelled), but Nat's Dad also sent along with CNET piece that explains all that this tool can do .   Here's the list: 1.  Test batteries 2.  Check extension cords 3.  Determine the life of lightbulbs 4.  Identify the 'hot' wire 5.  Find bad switches So...turns out, it wasn't all bird stuff at Christmas this year, right?!?