Why I Oughta...

Yesterday, I posted a photo of the set of legs that I had built that were the beginning of my new miter saw station .  Today, you can see the two frames that I built that will go on top/in the middle of those set-ups.  The leaner one on the left is the one that will go on the bottom and be the bottom 'shelf' and the wider one on the right will be the shelf that the bottom of the saw sits on top of.  There's another layer/level of platform that will sit at the very top that will be even with the table that is at the top of the saw.  Each of these were spec'd to be put together with pocket screws, so I went ahead and followed those directions.  You can see the pocket screw holes below: Let's call this step 2:  the bases are built out. 

This winter break, I've embarked on a few projects to get my shop up and running in the new house.  The first project is a mitre saw stand.  I figure that if I get my saw up off the floor onto a stand, I can then begin to make a few other tables/benches to host the other tools and what-have-yous that I've collected over the years.  I have two Christmas's worth of tools to unpack and set up and actually use. I'm using this plan from the Home Depot with a few modifications including the addition of this Kreg Precision Trak and Stop Kit , so that will require me to use a thicker fence than what is spec'd in the plans.  I also think I'm going to add a dust shroud and dust collection near the end.  But, the first few steps in the plans - which focus on the legs and the base pieces, I'm going straight by the plans.  In the photo above, you can see the four legs that I put together with 2x4's and a 2x6.  The plans call pocket screws, so that's what I