Why I Oughta...

Bench via WoodsmithPlans.com In March of this year, I posted a photo of a wall-hung workbench that I came across on Instagram .  The photo above is of that same bench, but comes from the source of the plans:  Woodsmith Plans .  They're offering a plan for sale for the bench plus the tool holder above and the little shelf for hand tools on the very top for $10 .  I think I've settled on going with this direction for both a bench in my shop in the basement, but also for a garden bench that I'm now planning in the garage. This whole thing started with this initial wall-hung workbench with curves that I found online at the WoodArchivis t.  But, in looking at the space constraints that I have in my shop, coupled with some concerns about the rigidity of the curved superstructure, I've kind of drifted away from my initial plan.  In the shop, my plan calls for hanging the bench on concrete walls, which requires cleats or ledgers (as in this design above)....

The last time we checked in on my basement workshop was a ll the way back at the beginning of April when I posted about the new wall and sealed, exterior door that were installed , thus, creating the shape of the shop.  Then Spring came and all of my attention and time were focused outside on the garden and yard.  I left the shop empty and forgot all about my plans to finish the floors.   Well, the recent run of super hot weather afforded me the opportunity to get back going on the shop and job #1 was finishing the floors.  I had, on hand, a couple of the Rocksolid Metallic Epoxy floor kits that I bought back in April when I was planning the shop build out.  Inside of each of those kits was a package of 'floor etch', which I got busy with.  Below, in the first photo, is after one round of etching the floor.  I did it 2x - just to be safe.  But, since there isn't a floor drain, I ended up having to saturate the floor (post etch) and then...

Just a few days ago, I posted about the progress being made in the construction of my #newoldworkshop down in the basement.  I shared a photo of the wall being framed in here .  Today, you can see the door installed and the sheetrock attached to the outside of the framing.  If you look closely, you'll also see the dust vent up near the top of the framing.  The door on the right is the door to our "Christmas Closet" and was already built by our builder's team.  As I mentioned in the post outlining all the 'to do's' for my shop , I used an exterior door with weather seal to keep the dust contained.  I'm also planning on painting the walls in the shop to brighten up the space and lay down some of that epoxy garage floor coating to spif the place up.  And, I've been reading up on dust collection systems including this one from GeekBea t.  I like his ducting/routing/termination system.  But, I'm thinking of going a different route in terms o...

After months of planning and thinking and posting about my eventual workshop, we finally have progress:  the wall that divides the rest of our basement with my shop is getting installed.  In the photo above, you can see the wall being framed and the steel door - an exterior door - installed.  On the right side of the photo - through the framing - you can see the existing stairs and banister coming down from the first floor.  In the middle of the room, you can see an existing door/wall that built out by our builder to contain the mechanical room.  They used a steel, exterior door on the mechanical room, so we replicated that with the door for my shop.  They're going to be so close, so it was important for them to match. Right after the wall framing is done, drywall is going on the outside, but I'm going to leave the inside unfinished.  I'm still planning on cutting in a spot for a vent ( see here for inspiration ) and stuffing the joist cavities wi...